RecordWell Data

Manufactured Home Packet

Edgefield County · Edgefield County · meeting of Dec 18, 2018 · Agenda packets

Open the original document More from Edgefield County

Text

Extracted automatically from the original. Tables and formatting may not survive; the original document is authoritative.

EDGEFIELD COUNTY BUILDING & PLANNING 210 PENN ST. EDGEFIELD, SC 29824 (803) 637-4073 Installing Your Manufactured Home In Edgefield County South Carolina Contacts: Edgefield County Building & Planning (803) 637 - 4073 Edgefield County Tax Assessor (803) 637 - 4066 DRIVEWAYS: Edgefield County Road (803) 637 - 4073 S.C. Dept. of Transportation (State Road) (803) 637 - 6511 ELECTRIC COMPANIES: Aiken Electric Cooperative (803) 637 - 3189 South Carolina Electric & Gas (803) 275 - 2534 WATER & SEWER: DHEC (Department of Health & Environmental Control (803) 637 - 4035 DHEC (Aiken Office-206 Beaufort St, NE, Aiken, SC) (803) 642 - 1637 Edgefield County Water & Sewer (803) 637 - 3011 MANUFACTURED HOME CHECKLIST 1. Get a tax map number from the Tax Assessor’s office. 2. Bring copy of plat for approval to the Edgefield County Building & Planning Office. Once approved you will receive a Site Approval form to take to the DHEC office for a septic permit. If you have an existing septic tank please contact a Certified Septic Tank Installer for an Approval Letter. If you are on County Water and/or Sewer, go to Edgefield County Water and Sewer Authority (ECW&S) for approval to connect. The fee will be set by DHEC or the Water and Sewer Authority. We require a copy of the authorizations and/or test results from DHEC and/or ECW&S prior to any further work. 3. Get a 911 address from the 911 Administration (637-4106). 4. Register the home in the Tax Assessor’s Office. The fee is $10.00. The following paper work is required: a sta mped site approval form from the Edgefield County Building and Planning Department and Form 400 or title. Form 400 comes from the dealer. A decal will be issued. This decal should be placed on a window facing the driveway. 5. After the home is registered, go to the Edgefield county Building & Planning Office and pay the mobile home fee (depending on cost of home). 6. Alternative Methods of installation MUST be approved by the Manufacturer. 7. Installer must have a moving permit if the home is not being purchased from a dealer. This permit is issued from the County that the home is being moved from. The Edgefield County moving fee is $50.00 and is issued by the Tax Assessor’s Office (803-637-4066). 8. After installation is completed, you will need to contact the Edgefield County Building & Planning Office for a final inspection. The following items must be complete: Anchors, Piers, sewer and water pipes (must leave an opening in the underpinning), also septic tank installed or sewer hooked up, copy of final septic tank approval from DHEC, landings with steps and handrails in place, landing secured to ground, electrical complete, 911 address posted (visible and legible from th e street or road fronting the property), tax decal in window, driveway completion and u nderpinning. The tongue and tires must be removed. If you desire to leave tongue on, you must pay a tongue deposit of $150.00 at the Treasurer’s Office. A form to authorize the deposit must be obtained from the Building and Planning Department. The fee is refundable if the home is moved out of Edgefield County. 9. If all the above items are completed, the Building and Planning Department will authorize power. This authorization will be faxed to the power company which is the supplier for your address. DRAINAGE The home must be provided with adequate drainage to allow the runoff rain water to flow away, not under, the home. It may require the excavating of a trench to divert to the flow or the installation of a drain. Water that is allowed to flow under the home will cause rot and mildew and could possibly undermine the piers and cause sagging and damage to your floors. DRIVEWAYS A concrete pipe of at least 15” in diameter must be placed under the driveway at the drainage ditch. This is required by the Edgefield County Road Ordinance. Any questions regarding this installation should be directed to the Edgefield County Building & Planning Office (803-637-4073). E 911 NUMBERS In order that emergency vehicles can locate your home in the event that you require assistance, you must display the number assigned to you by the 911 office on your home. If your home cannot be viewed from the road, place the number at your driveway and on your home. ELECTRICAL CONNECTIONS All electrical work must comply with the National Electric Code. You may perform this work yourself or hire a S.C. licensed electrician. As per the HUD Manual, Sec. 3280.803(k)(3)(i), installation of the meter receptacle on the side of the home can be done ONLY by the manufacturer. You will be required to obtain a meter receptacle from the power company or in the case of SCE&G, obtain one from an approved supplier. All manufactured homes also require a disconnect panel installed at the meter location. The size of the disconnect is determined by the power requirement of the home, i.e.100, 150 or 200 amp. There are two types of service, overhead and underground. The illustrations attached will assist you in the installation of these electrical panels. PLUMBING All plumbing connections (water, sewer, etc.) must be made in accordance with the International Plumbing Code. All pipes under the home must be supported by metal strapping at no more than 5 foot intervals, proper slopes must be maintained to allow drainage on sewer lines. All joints in plastic piping must be glued with an approved cement for the pipe being used. Green pipe can be glued to either ABS or PVC. All plumbing connections need to be left uncovered until after inspection. REGISTRATION DECAL The decal that will be provided to you at the time you register your home must be placed in a window that faces the roadway or driveway in order that it can be seen from a vehicle without driving off the road or driveway. SITE CLEARING The site under the home must be cleared of all organic materials, grass, roots, stumps, weeds, etc. A plastic vapor barrier may be installed using 6 mil or better plastic sheeting. STEPS All door openings must be equipped with a set of steps with a minimum landing of 36” by 36”. Steps shall not have a rise of more than 8 1/4” per step. Anywhere a step or landing is 30” or more above the ground, it must be provided with a handrail at least 30” tall and have vertical pickets spaced to allow no more than a 4” opening. Wooden steps must be constructed of pressure treated lumber and fastened together with galvanized fasteners. If the landing/steps are not set into the ground, they must be secured with a ground anchor and strap so that the landing/step cannot turn over or be pushed over. If masonry steps are used, the blocks or bricks must be mortared and provided with handrails if required. Steps & Landing Handrail height – 34-38” Measured from nosing of each tread. Pickets required on handrails when landing is 30” or more to grade. Pickets must be spaced 4” apart or less. Tread: 10 inch minimum Riser: 8 1/4 “ maximum Steps & landing must be freestanding. Landing MUST NOT be attached to mobile home. All exterior doors must have a landing the width of door x 36” deep Minimum guardrail height 36” If landing is more than 30” above grade, guard- rails are required. Threshold of door must not be more than 8 ¼” above landing. If door swings over landing, threshold must not be more than 1 ½” above landing. 4” x 4” pressure treated posts HANDRAILS R311.5.6 Handrails. Handrails shall be provided on at least one side of each continuous run of treads or flight with four or more risers. R311.5.6.1 Height. Handrail height, measured vertically from the sloped plane adjoining the tread nosing, or finish surface of ramp slope, shall be not less than 34 inches (864 mm) and not more than 38 inches (965 mm). R311.5.6.2 Continuity. Handrails for stairways shall be continuous for the full length of the flight, from a point directly above the top riser of the flight to a point directly above the lowest riser of the flight. Handrail ends shall be returned or shall terminate in newel posts or safety terminals. Handrails adjacent to a wall shall have a space of not less than 1½ inch (38 mm) between the wall and the handrails. Exceptions: 1. Handrails shall be permitted to be interrupted by a newel post at the turn. 2. The use of a volute, turnout, starting easing or starting newel shall be allowed over the lowest tread. R311.5.6.3 Handrail grip size. All required handrails shall be of one of the following types or provide equivalent graspability. 1. Type I. Handrails with a circular cross section shall have an outside diameter of at least 1¼ inches (32 mm) and not greater than 2 inches (51 mm). If the handrail is not circular it shall have a perimeter dimension of at least 4 inches (102 mm) and not greater than 6¼ inches (160 mm) with a maximum cross section of dimension of 2¼ inches(57 mm). 2. Type II. Handrails with a perimeter greater than 6¼ inches (160 mm) shall provide a graspable finger recess area on both sides of the profile. The finger recess shall begin within a distance of ¾ inch (19 mm) measured vertically from the tallest portion of the profile and achieve a depth of at least 5/16 inch (8 mm) within 7/8 inch (22 mm) below the widest portion of the profile. This required depth shall continue for at least 3/8 inch (10 mm) to a level that is not less than 1¾ inches (45 mm) below the tallest portion of the profile. The minimum width of the handrail above the recess shall be 1¼ inches (32 mm) to a maximum of 2¾inches (70 mm). Edges shall have a minimum radius of 0.01 inch (0.25 mm). RESTRICTIONS Pre-1977 MANUFACTURED HOMES Manufactured homes titled prior to June 1976 does not meet the Housing and Urban Development (HUD) requirements and cannot be used in Edgefield County without meeting the County ordinance concerning manufactured homes. You need to contact the Building and Planning Department prior to the purchase of this home or moving this home to another site. PENALTIES Failure to license, register, or obtain proper permitting for a manufactured home located within the unincorporated areas of Edgefield County shall be punishable as a misdemeanor and subject to a fine not to exceed $500 per day. Warning! Read below before connecting to Service-Entrance Equipment The electrical system of this home has been designed for a 4-wire feeder system. The grounding system is isolated from the neutral system. Be sure to connect a separate insulated, green colored conductor to the service ground in the service-entrance equipment located adjacent to or near the home. All bonding screws, straps or buses in this main electrical distribution panel as well as on all appliances, have been removed and discarded. Two ground rods or grounding electrode conductors, 8ft min and 6ft apart are required. Connecting to a 3-wire system is a violation of the applicable National Electric Code and increases the risk of electrical shock and fire. PLEASE READ THE FOLLOWING CAREFULLY! Electrical power will not be authorized until your home is completely installed with all the steps, skirting in place and all inspections completed and approved. The home must be registered with the Tax Assessor’s Office and ALL fees paid in full before home is moved to the site. Edgefield County is not responsible for promises made by dealers and sales people regarding completion in a given time frame. The time for proper installation of a manufactured home is dependent upon many factors including but not limited to the guidelines in this manual. Edgefield County’s primary concern is the safety and habitability of all homes placed within the county. Manufactured homeowners are asked to reinforce this message to the dealerships where they purchase their homes. SOUTH CAROLINA MANUFACTURED HOME INSTALLATION CERTIFICATION Customer __________________________________________________ Date _________________________ Address Where Home Is To Be Installed ________________________________________________________________________ Private Property Park Manufacturer/Year/ Model ___________________________________________________________________ New Pre-Owned Single Section Multi-Section Serial Number ______________________________________________________________________________ Retail Center _______________________________________ Salesperson __________________________ Licensed Installer _____________________________________ License No. ___________________________ Installer Address ___________________________________________________________________________ Installer Phone _____________________________________ I CERTIFY THAT THE MANUFACTURED HOME HAS BEEN INSTALLED IN ACCORDANCE WITH THE INSTALLATION GUIDELINES OF THE MANUFACTURER AND THE REGULATIONS ESTABLISHED BY THE SOUTH CAROLINA MANUFACTURED HOUSING BOARD. SCMHB Regulation No. 19-425.16B(3) ____________________________________________________ ____________________________________ Licensed Installer Date ______________________________________________________________ _______________ ____________________________ Sales Manager Date Approved for use by the South Carolina Manufactured Housing Board Rev.8/97

Source: Edgefield County website. First collected Nov 3, 2026.